WEEK 14

Activity

Presentation

Objectives

To present the functionality of the machine in Industry day

Procedures

Prepare poster presentation

Results & Analysis

Industry Day with GM form Technology Park Malaysia, Mr Azrai

Conclusions

Alhamdulillah, everything went well. Thank you

WEEK 13

Activity

Troublehooting

Objectives

To troubleshoot the problem occur

Procedures

Check the supply. check the sensor connection. Check the LCD connection. Check all the functionality of the sensors.

Results & Analysis

All sensor are in good condition and function well except for the load cell. There is no output occur from the load cell sensor. 

Conclusions

All troubleshooting has been done and discover that only one sensor cannot be used.

WEEK 12

Activity

Construct incubator box

Objectives

To construct using acrylic 

Procedures

Get the dimension for the incubator, make a partition for the wiring connection

Results & Analysis

Conclusions

The incubator are made rigid and safely to used. All the components has been attached to the incubator box.

WEEK 11

Activity

Coding

Objectives

To compile all coding program 

Procedures

All coding were compile all together and test run overall machine functionality

Results & Analysis

After compiling all the coding, there are some problem pop up regarding to the coding itself

Conclusions

Troubleshooting are needed for this problem

WEEK 10

Activity

Arduino with load cell sensor and LCD

Objectives

To display the value of the load cell on the LCD

Procedures

Create coding on the load cell to interface with the LCD

Results & Analysis

Conclusions

The value of the weight did not been displayed on the LCD, there must be a problem on the coding program.

WEEK 9

Activity

Arduino with LCD and Height sensor

Objectives

To create coding program for the sensor to be interface with the LCD and Arduino

Procedures

When there is an object in the parameter of the sensor, the sensor will be detect the sensor and LCD will show the output value.

Results & Analysis

Conclusions

The sensor succeed to detect the object's height measurement and display on the LCD

WEEK 8

Activity

Arduino, LCD and DHT11 with Fan and Heat Lamp

Objectives

To set the parameter for DHT11 to be interface with fan and heatlamp

Procedures

Create coding for the DHT11 that set the specific parameter. when the Temperature is too high, the fan will be activated. when the Temperature is too low, the heat lamp will be activate

Results & Analysis

Condition for fan and heat lamp to be activate

Relay module

Conclusions

The coding program succeed to justify the condition of the DHT11. The relay module used to give signal to the heat lamp and fan.